High efficiency electric road trowel 
 First, use 
 Equipment for the latest concrete surface, coarse and fine grinder with. After the construction surface of this equipment is more smooth, more smooth, can greatly improve the density, abrasion resistance of concrete surface. Can greatly improve work efficiency, compared with manual operation can be increased by more than a few times. This machine is widely used for concrete pavement, floor, airport, floor. 
 Second, the main technical parameters 
 Model DSM600-1000 
 Motor power 3KW 
 Wipe disk diameter (mm) 600-1000 
 Per minute speed 60-100r/min 
 Blade adjustable angle of 0-15 

 Third, the main agency principle 
 This series of four-leaf trowel Direct turbo reducer transmission of power, with a reduction ratio of high efficiency and high characteristic. The agency made for motor gasoline by the triple burner belt drive turbo box, so as to drive the rotation of the trowel to achieve a smooth turbine drive, the drive torque, durable, smooth, uniform speed, etc.. The biggest advantage of this machine can do in one machine, the coarse grinding grinding turn the hand wheel adjustable, smear the angular size of the rough wiping or fine wipe. 
 Four, attention must be strictly in accordance with statutes, or may cause personal injury. 
 A new machine After unpacking, you want to handle straight, screw nut installed with a wrench tightening. The hand wheel to the left light spin in the end. First rope buckle re-AS wear, and the two nuts were tightened shall not be loose. 
 2, the operation to be done carefully check the zero line to ground, electrical motors, cables, etc. are intact, whether the water, he must overhaul. And check the handle screws fixed tighten. 
 3, clean the smear on the dirt, scratches to prevent the construction of the concrete surface. 
 4, the access power supply cable must be used more than a single cut 1.7MM cable and grounded four-core cable, pay attention to the switches below the ground in mind that the ground must be reliable. 
 5, the overhead of the machine, the smear touching the ground, power, try to turn View smear the direction of rotation. Be careful prohibited leaf flip, or likely to cause harm 
 Boot, when the When smear rotation in the right direction, his hands clenched, and force control handle, but you can not handle under pressure or elevation, left hand turn on the switch, slowly rotating smear to smear the normal rotation to work. 
 Leaves work, the first disc removed, and then will handle round to the pointer to the direction of rotation, the nut go to the 100-150cm length, the rope connected to the bottom of the strut, its locking in turn the hand wheel back to the leaves turn to about 15 ° to work properly. 
 8, mobile construction, the elevation of the handle or under pressure, the equipment itself and move around. Need to forward and back forward or backward pull. Note that handle elevation or forced under pressure, not too heavy, otherwise it will create moving too quickly can not control. 
 9, operation, the operator must wear soft-soled insulated shoes must be with insulated gloves; 
 Fourth, security matters 
 1, the construction, pay attention to the temperature of the motor gear box shall not exceed 80 ° degrees 
 2, the turbo tank of oil need to frequently check the oil standard, such as below the oil standard fuel in a timely manner. After each use to clean-up equipment, especially smear should be clean and stored in a dry and clean and not corrosion environment. Smear wear to unilateral 30mm to loosen the nut, the smear to make a U-turn to re-screw tightened to achieve two purposes. Smear angle size to turn the hand wheel to adjust the angle of the smear, in order to achieve the desired effect of the crude wipe. Construction such as the need to stop please turn off the power. The gasoline engine shutdown, press the switch on the handle in a timely manner to stop. 
 , The vulnerability of the leaf disc Triangle bearing.